#HOW TO CHANGE HUAWEI PASSWORD HOW TO#
#HOW TO CHANGE HUAWEI PASSWORD SERIAL#

#HOW TO CHANGE HUAWEI PASSWORD HOW TO#

If you have not obtained the access permission of the document, see Help on the website to find out how to obtain it. The default username and password are available in S Series Switches Default Usernames and Passwords ( Enterprise Network or Carrier). When the message 'Press Ctrl+B to enter Boot Menu :'is displayed, press Ctrl+B and enter the password to access the BootROM main menu.

#HOW TO CHANGE HUAWEI PASSWORD SERIAL#

Connect a PC to the switch using a serial cable and restart the switch.Then insert the standby MPU after the restart. If the switch has two MPUs, remove the standby MPU before restarting the switch.Do not power off the switch during the operation.Configure a new password immediately after clearing the console login password and logging in to the switch.Back up service configuration and perform this operation in off-peak hours. You must restart the switch to display the BootROM menu, which results in service interruption.Now saving the current configuration to the slot 4. The current configuration will be written to the device. Save the configuration to prevent configuration loss after a restart.set authentication password cipher return The following example changes the authentication mode to password authentication and the password to system-view Idx Type Tx/Rx Modem Privi ActualPrivi Auth Int The command output shows that VTY1 corresponds to user right level 15, which has the right to change the console login password. Run the display user-interface command to display rights of all users. User-Intf Delay Type Network Address AuthenStatus AuthorcmdFlagДЎ29 VTY 0 00:23:36 TEL 10.135.18.67 pass no Username : Unspecified The item marked with the plus sign (+) indicates your user account, which corresponds to VTY1. Run the display users command to display all the users who have logged in to the switch. Ensure that your user right is level 3 or higher. If you have an STelnet account and user rights of level 3 or higher, log in to the switch using STelnet, change the console login password, and save the configuration. This section describes how to log in to a switch using STelnet and change the console login password. Logging In to a Switch Using STelnet/Telnet and Changing the Console Login Password

How to change huawei password